Reef Angel Forum

hi all I am new here...
and I hope this is the best place to add this thread.
I have a few question before I buy.

I have meanwel's ELN 60-48D drives for my DIY LEDs...
1) what module will work? I am thinking the PWN one.
2) am I correct in my understanding the there is built in port for dimming?
3) would I need the lead dimming port wire? I am think so...
4) can you use any wifi attachment? or just the one on the RA website?
5) does the wifi signal interfere with other wifi signasl on a N wireless band say like XBoX or netflix?
6) can I have more that one float switch. low turn on ATO high turn off ATO higher safety off, as well as one on the ATO res.

I am sure I have more questions but this is a start .
thank you for your time!

1. You need the Analog dimming.
2. Built-in
3. Yes
4. No. Just the RA wifi attachment.
5. No. It actually uses G not N
6. Yes, you can do that.