Reef Angel Forum

My wifi usually only says online about 24 hours before I have to reset it. I read on another post that I should update my firmware. I tried to do this via the wifi utility and get the message below. I see where it states: UPDATE OK, should I assume the update occurred and the error message occurred after the fact?

Opening Serial Port...
Connected to serial port COM3
> $$$
< CMD
> ftp u
< ftp u
< <2.38.3>
< FTP connecting to 198.175.253.161
< FTP file=68
< .........................................................
< FTP OK.
< UPDATE OK
> ftp r wps.img
< ftp r wps.img
< <2.38.3>
< FTP connecting to 198.175.253.161
< FTP file=34
< ...................................
< FTP OK.
< GET /r99 HTTP/1.1
< Host: xxxxxx
< Connection: Keep-Alive
<
< GET /r99 HTTP/1.1
< Host: xxxxxx
< Connection: Keep-Alive
<
> reboot
** ERROR - Please disconnect and then reconnect the Reef Angel Wifi Attachment from the USB-TTL cable and try again.

Removing connection to COM3

You have the client constantly trying to connect to the module which is probably what is causing it to generate that error, but I can see you already have latest 2.38.3 f/w version.

Thanks for taking a look.

Not sure why the persistent connection is happening, I just tried to update the firmware from the wifi utility. I didn't do anything manually or with the prompt.

I meant you have the Reef Angel Client app constantly trying to connect while you are trying to change settings. This indicates the connection attempts