Reef Angel Forum

That was it thanks Roberto. Next challenge seems my controls tab on the iPhone App are working but the names for the relay box are not accurate with how I have my actual relay box configured? How can I change the names?

Controller Code (Same code I was using prior to Wifi Adapter being added?) // Autogenerated file by RAGen (v1.2.1.158), (05/23/2012 20:25) // RA_052312_2025.ino // // This version designed for v0.9.0 or later /* The following features are enabled for this File:  #define DisplayImages #define DateTim...

Finally got wifi adapter working and web page works when entering my IP address. I then wrote a memory code with the RAGen and yes I enabled the wifi. Not sure where I am falling short. I have attached memory code and Controller code. PLease help am i doing something wrong? Not quite grasping the co...

Ok thanks Robert I'm going to call it a night and I'll attempt again tomorrow. Thanks again for all your help!

Nothing. To ensure I have test code procedure right.... I selected wifi test from examples menu, uploaded to controller and as soon as that was done I connected the wifi module. The module had a blnking green light but on the actual controller screen it showed wifi setup already done and then at bot...

How can I screen shot it into this forum? It does say Associated: true Authenticated: true DHCP: true Mode: WPA2 IP address and port: 192.168.1.67:8080 Then the verbiage about if blue light is still blinking ...wifi could not connect to network FYI I have a steady blinking green light no blue so I a...

Ok got the wifi module connected to network but when I uploaded the wifi test code to the controller then connected to wifi module and entered the ip address given during the setup on the wifi utility nothing comes up with that ip address? Am I completely missing something? Another question is the p...

I have no idea what the heck is going on but it is strange. I cannot access the setting for the router I am currently using so I cant even apply a passcode making my wireless become ecrypted so.....I am purchasing a new Router Modem today and will install with passcode and start over fresh. Ill keep...

Following steps listed in wifi tutorial but it's nit working. I select com port used for other RA uploads, select Baud rate 9600, click connect, apply basic settings, click ok after baud rate is updated to reconnect. I then enter Auth Mode 0 (open) and I verified under wireless settings that's what ...

Controller Menu --> Internal Memory It was moved and the documentation hasn't been updated yet. Thanks for the help! Just ran into another setback...seems the ph probe was damaged at some point resulting in the glass bubble tip of the probe breaking off in the solution bottle the probe was packed i...

Bear with me guys I am just getting started. I have Arduino installed and RAGen. When I opened RAGen and went through the steps as mentioned in the forum I am not seeing the Internal Memory Tab in order for me to setup my initial memory setting and upload it? Any suggestions.

Hey guys I'm thinking about swapping my meanwells for the D version. Does going from the P to D really make a difference (5% from 15% at the lowest)? Where can I get that conversion cable? I saw some DIY sites but I'd rather buy it at this point. Thanks. J ^^^^^^^^^^^^^^ X 2. I am also interested i...

Robert1969 wrote:Thank you I'll have to give that a try

Did this work for you Robert

You are all set :) You can leave the drivers on the wall. Great so I guess my next step would be reallocating the daylight, moonlight, and actinic plugs on relay box. Would it be possible to rename/assign 1 for a GFO reactor that also adds a function on the display to turn on and off via the joysti...

I am unboxed and ready for setup of my RA. I just completed my DIY Led fixture and when ordering my drivers RapidLed recommended I choose the Mean Well ELN-60-48P dimmable drivers. Is this ok in regards to the RA controlling them and in addition I ordered the PWM Port lead wire and not the PWM-analo...