got a new temp port tonite and it seems to have remapped all my ports based on the serial number of the probe, a known issue.
In my code, though, will my maps still work? Is the hardware port T2 (the middle one on the head unit) still T2 in my code? The cable still goes the same place, it just appears in a difference place on the portal.
Please advise. Thx
mapping temperature ports
-
rossbryant1956
- Posts: 471
- Joined: Sat Jan 14, 2012 2:08 pm
- Location: Montgomery Village, MD
mapping temperature ports
Roscoe's Reefs - Starting Over Again:
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
-
lnevo
- Posts: 5422
- Joined: Fri Jul 20, 2012 9:42 am
mapping temperature ports
No. Easiest bet is to rerun the cables to match what you expect...
Otherwise you have to change your code to point to the new numbered probe for overheat and standard heater control.
Otherwise you have to change your code to point to the new numbered probe for overheat and standard heater control.