Basic float switches water exchange

[semik]

Hi Guys,
I like to have basic float switches water exchange.
I will mount floats in tank in this position:

float2_zps0e9a4ed5.jpg (7.29 KiB) Viewed 4697 times

What i want is when low water level, switch A set port 8 on and when level is ok switch B set the port 8 off.
The reason is that i don't want auto water change but custom when needed.
Can anyone help with code?

Thank you.

[lnevo]

That's essentially what the StandardATO function does.

ReefAngel.StandardATO(Port8,60);

Where 60 is the number of seconds as a backup in case float switch B fails.

[semik]

Thanks a lot Inevo for quick answer.

So if i want to set it for 10 minutes switch fails it is like this:

ReefAngel.StandardATO(Port8,600);

[lnevo]

Yes. Base that timeout on the pump you are using. 600 seconds = 10 minutes. So if somethign fails that pump will run for 10 minutes...

[semik]

Thanks a lot Inevo.

This port is actually running solenoid valve and i need around 9 minutes to refill tank, so it should be ok if it is counting 10 minutes from on to off.

[semik]

In the future i will replace it with Multi-Channel Water Level Expansion and set it up to run 3 tanks if it is possible.

[lnevo]

Yeah very possible. I dont think you can use the standardato function more than once yet, but i think roberto has a fix for that. But we can easily code around that if so when your ready.