I updated to a new computer and in the process seemed to have lost my RA and internal memory codes that I had saved. Is there any way to plug my computer into the RA and have it show me the code in arduino so I can save it? It took a lot of help to get it where it is, and now I can't find it nor remember how I did it. I could always use the wizard or generator, but there were a couple of unique functions.
Thanks
Ryan
recovering arduino code
-
rossbryant1956
- Posts: 471
- Joined: Sat Jan 14, 2012 2:08 pm
- Location: Montgomery Village, MD
Re: recovering arduino code
unfortunately, no. All I've read so far has said it's not possible. Perhaps with these new tools coming out, there is hope.
Roscoe's Reefs - Starting Over Again:
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
-
rossbryant1956
- Posts: 471
- Joined: Sat Jan 14, 2012 2:08 pm
- Location: Montgomery Village, MD
Re: recovering arduino code
didn't think of this before but most of my code has been written with the help of this board...if you'll click "view your posts" at the top of this page, you'll find all your previous discussions.
Roscoe's Reefs - Starting Over Again:
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.