Reef Angel Forum

I updated to a new computer and in the process seemed to have lost my RA and internal memory codes that I had saved. Is there any way to plug my computer into the RA and have it show me the code in arduino so I can save it? It took a lot of help to get it where it is, and now I can't find it nor remember how I did it. I could always use the wizard or generator, but there were a couple of unique functions.

Thanks
Ryan

unfortunately, no. All I've read so far has said it's not possible. Perhaps with these new tools coming out, there is hope.

didn't think of this before but most of my code has been written with the help of this board...if you'll click "view your posts" at the top of this page, you'll find all your previous discussions.