Reef Angel Forum

Hi

Greeting everyone. I just got my new controller, It's Basic set.
Got some problem with code upload. Everytime I tried to upload sketch I alwasy got below

avrdude: Version 6.0, compiled on Apr 6 2012 at 19:29:19
Copyright (c) 2000-2005 Brian Dean
Copyright (c) 2007-2009 Joerg Wunsch

System wide configuration file is "C:\Program Files (x86)\Reef Angel Controller\hardware/tools/avr/etc/avrdude.conf"

Using Port : \\.\COM7
Using Programmer : stk500v1
Overriding Baud Rate : 57600
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv: 0 [30]
avrdude: stk500_getsync(): not in sync: resp=0x30

I had set board setting to Board --> Reef Angel controller
Anythink else do I need to set? (Programmer, Buad rate.) To make upload successful.

Please help
Thanks you

Choose Reef Angel Controller w/ optiboot

rimai wrote:Choose Reef Angel Controller w/ optiboot

Hi

This is an error when I use the above option
avrdude: Version 6.0, compiled on Apr 6 2012 at 19:29:19
Copyright (c) 2000-2005 Brian Dean,
Copyright (c) 2007-2009 Joerg Wunsch

System wide configuration file is "C:\Program Files (x86)\Reef Angel Controller\hardware/tools/avr/etc/avrdude.conf"

Using Port : \\.\COM7
Using Programmer : arduino
Overriding Baud Rate : 115200
Rebooting Reef Angel Controller
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x64

avrdude done. Thank you.

Do you have standard RA or RA+???
Are you sure it is COM7?

rimai wrote:Do you have standard RA or RA+???
Are you sure it is COM7?

Roberto he is using a standard RA 32k

rimai wrote:Do you have standard RA or RA+???
Are you sure it is COM7?

I think it is. As when connected USB com7 is automatic display in the list. And when I try to upload. It's does not complain on connection error at all.

Is there any other option besides COM7?

rimai wrote:Is there any other option besides COM7?

No, Is is only 1 port to display and select.
BTW
- what is programmer should I use currently default at AVRISP MrkII
- Anything to do with this --> Overriding Baud Rate : 115200
Is it should be --> 57600 If yse how to change it?