How to set 16 channel dimming expansion, 10v~5v, PWM~analog

sesame · Post by **sesame** » Sat Jan 17, 2015 6:41 am

hello Roberto:
very glad to start setting my 16 channel expansion. but have some question about this module
is it possible to swap from 10v to 5v. how to? and if possible to swap PWM to analog.

and also find 6 Jump (J1~J6), what's these purpose?
thank you very much.

lnevo · Post by **lnevo** » Sat Jan 17, 2015 6:54 am

I think it's hard coded to the configuration, the jumpers I think are for the i2c address, but I'm just guessing. Let's see what Roberto says

rimai · Post by **rimai** » Sat Jan 17, 2015 9:11 am

The jumpers are for I2C address.
You don't need to touch them if you don't have more than one.
The module was designed to be 0-5V PWM only. No signal changes were implemented in that module.

sesame · Post by **sesame** » Tue Jan 20, 2015 7:05 am

understand. but prefer to have at least pwm analog swap ability next time.

Reef Angel Forum