Page 1 of 1
Controlling Mobius enabled VorTech pump using 0-10V (& BLE)
Posted: Wed May 05, 2021 5:14 pm
by howaboutme
I ran across this thread on R2R and thought it would be relevant here for any of the advanced coders:
https://www.reef2reef.com/threads/contr ... le.814921/
github file here:
https://github.com/treesta1ker/arduino-MobiusBLE
Any possibilities here?
Re: Controlling Mobius enabled VorTech pump using 0-10V (& B
Posted: Wed May 05, 2021 5:41 pm
by rimai
Pretty cool.
That's basically the work I had done with the old RF module.
Reverse engineering of the messages.
Unfortunately, RA doesn't have a BLE radio
Re: Controlling Mobius enabled VorTech pump using 0-10V (& B
Posted: Wed May 05, 2021 6:23 pm
by howaboutme
Ah yes, BLE. That is the trend, though I dislike it, connections are horrible.
Incidentally, I have a couple of vortechs to play with. I have one w/ the old original green RF chip and one with the Mobius chip. I downgraded the drivers on the Mobius one and was able to connect it to the Reeflink. I had thought we had to replace the Mobius chip w/ the old green chip to do that but that is not the case. Apparently the Mobius chips have both BT and wifi capabilities. I have not made it a slave and connected it to the RA yet though.